Parr-instrument Motor Control Module (MCM) Manuel d'utilisateur télécharger pdf (Page 3)

MCM Installation

www.parrinst.com

Wiring Installation in 4848 Reactor Controller

1. If applicable, remove the black hole plug on the back of the controller labeled RPM INPUT. This can

be done by pinching the clasps on the back of the plug from inside the back panel.

2. Insert the 4-pin receptacle (494E), on the A2106E harness, into the RPM input hole from the inside

out. Slide the ring terminal, from the A2106E green wire, onto one of the mounting studs. Mount the

receptacle using the (2) #4 keps nuts provided.

3. Locate the A1695E excitation board as shown.

A1695E Excitation Board

TACH OUT

TACH IN

1 2 3 4 5 6 7 8

Pas de commentaire

Parr-instrument Motor Control Module (MCM) Manuel d'utilisateur Page 3