Parr-instrument MTM Manuel d'utilisateur télécharger pdf

Installation Instructions for Motor Torque

Module (MTM) in a 4848 Reactor Controller

560M

Warning: The Motor Torque Module can only be used in

conjunction with a Motor Control Module (MCM). The

MCM must be installed before installation of the Motor

Torque Module. For Motor Control Module installation,

see Field Installation Manual 555M.

Meter Installation in 4848 Reactor

Controller

1. Unplug the power cord of the 4848 Controller.

Remove the (2) screws located on the top/front

cover at the rear corners of the controller. Gen-

tly lift the cover forward, which is hinged at the

bottom, taking care not to apply tension on any

internal wiring.

2. If applicable, remove and discard the black hole

plug on the sloped front panel above the “PRES-

SURE” or “TEMPERATURE” text. This can be

done by pinching the clasps on the back of the

plug from the inside of the front plate. Place

“MOTOR OUTPUT” label over existing text.

3. Insert the MTM module (2084E) through the

panel cutout, from outside in, making sure the

rubber gasket is on the outside of the controller

front panel. (If wires are preinstalled, remove the

terminal connector by releasing the tabs on the

sides of the module and gently pulling the termi-

nal connector off. Reference photos below.) Slide

the white mounting bracket onto the module with

the mounting screws pointing towards the front

panel. Slide the mounting bracket forward until

it touches the controller panel. The clasps on the

mounting bracket should align with the groves

on the module. Gently tighten the screws until

the module is held into place. (If removed, reat-

tach the terminal connector.)

Terminal Connector Removal

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Controller

Installation Instructions for Motor Torque Module (MTM) in a 4848 Reactor Controller560MWarning: The Motor Torque Module can only be used in conjunct

Page 2 - MTM Installation

MTM InstallationParr Instrument Company2Meter Installation in 4848 Reactor Controller (Continued)Meter Installation Diagram Side Panel RemovalThe left

Page 3

MTM Installationwww.parrinst.com37 8 9 10 11 121 2 3 4 5 62084E Pin Out(Pin 5 is blank)Picture of MTM Meter 2084E Pin OutWiring Installation in 4848 R

Page 4

MTM InstallationParr Instrument Company4Wiring Installation in 4848 Reactor Controller (Continued)1. Locate wire 1 (red) from the package. Take the

Page 5

MTM Installationwww.parrinst.com5Reattach the side panel by slipping it back on and tightening the nuts.Close the controller and replace the two screw

Page 6

MTM InstallationParr Instrument Company6ModuleKeys command:1. Press “SET” to select 2. Press return key move to next operation mode3. Up/Down arrow

Page 7

MTM Installationwww.parrinst.com7This page intentionally left blank.

Page 8 - Revision 08/21/12

Revision 08/21/12

Commentaires sur ces manuels

Pas de commentaire

Parr-instrument MTM Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Parr-instrument MTM. Parr Instrument MTM User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Parr-instrument MTM