Parr-instrument Motor Control Module (MCM) Manuel d'utilisateur télécharger pdf (Page 1)

599M

Meter Installation in 4848 Reactor Controller

2100E Black Hole Plug

PLUG

CLASP

Motor Control Module (MCM)

for the 4848 Reactor Controller

Installation Instructions

1. Unplug the power cord of the 4848 controller. Re-

move the (2) screws located on the top/front cover at

the rear corners of the controller. Gently lift the cover

forward, which is hinged at the bottom, taking care

not to apply tension on any internal wiring.

2. If applicable, remove and discard the black hole plug

on the sloped front panel above the "RPM" text. This

can be done by pinching the clasps on the back of the

plug from the inside of the front plate.

3. Insert the MCM (2084E) through the panel cutout,

from outside in, making sure the rubber gasket is

on the outside of the controller front panel. (If wires

are preinstalled, remove the terminal connector by

releasing the tabs on the sides of the module and

gently pulling the terminal connector off. Reference

photos below.) Slide the white mounting bracket

onto the module with the mounting screws pointing

towards the front panel. Slide the mounting bracket

forward until it touches the controller panel. The

clasps on the mounting bracket should align with the

groves on the module. Gently tighten the screws un-

til the module is held into place. (If removed, reattach

the terminal connector.)

Terminal Connector Removal

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Installation Instructions

599MMeter Installation in 4848 Reactor Controller2100E Black Hole PlugPLUGCLASPMotor Control Module (MCM) for the 4848 Reactor ControllerInstallation

Page 2 - MCM Installation

MCM InstallationParr Instrument Company2Meter Installation in 4848 Reactor Controller (Continued)4. Mount the 1588E Signal Isolator, orient as shown,

Page 3

MCM Installationwww.parrinst.com3Wiring Installation in 4848 Reactor Controller1. If applicable, remove the black hole plug on the back of the contro

Page 4

MCM InstallationParr Instrument Company47 8 9 10 11 121 2 3 4 5 62084E Pin Out(Pin 5 is blank)Wiring Installation in 4848 Reactor Controller (Continue

Page 5

MCM Installationwww.parrinst.com5Wiring Installation in 4848 Reactor Controller (Continued)8. Find the remaining black wire #2 from the kit and attac

Page 6

MCM InstallationParr Instrument Company6Motor Control Module (MCM) Wiring SchematicP31 - WHITE22 - BLACK3 - WHITE4 - BLACK14 +6 -11 +REMOTEBM10RPM DPM

Page 7

MCM Installationwww.parrinst.com7Factory Default SettingsMCM ModuleKeys command:1. Press “SET” to select 2. Press return key move to next operation

Page 8 - 599M R02 Revision 11/08/13

599M R02 Revision 11/08/13

Commentaires sur ces manuels

Pas de commentaire

Parr-instrument Motor Control Module (MCM) Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Parr-instrument Motor Control Module (MCM). Parr Instrument Motor Control Module (MCM) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels